Head Assembly Detailed Request Form

To replace a head assembly or add a SAF-T-STOP Brake to an existing head assembly, it will be necessary for us to have the dimensional information (indicated by question marks) on the head assembly sketch.

SAF-T-STOP Brake parts diagram

References to part numbers in the description of the SAF-T-STOP brake operation can be found on the SAF-T-STOP Brake parts diagram document.

Please refer to the sketch and provide us with the following information:
(The questionnaire can also be downloaded in PDF format.)

Head Assembly Detailed Request Form

Name*
First Last
Company Name*
Email*
Phone*
A. Size of channel or I-Beam used for bedplate
B. Outside to outside of bedplate, across top
C. Distance from top of bedplate to centerline of head pulley shaft
D. Centerline of head pulley to outside of bedplate opposite drive
E. Centerline of head pulley to outside of bedplate, drive side
Approximate height of manlift from center of pulleys
Belt width
Does gear reducer have an extended output shaft?
- Yes
- No
Is there a flexible coupling between reducer output shaft and the head pulley shaft?
- Yes
- No
Motor Horsepower
Type of switch required on the Saf-T-Stop Brake
Number of steps on manlift
Bedplate made of channel steel?
- Yes
- No
Do the flanges face toward or away from each other?
Bore sizes of head shaft pillow blocks
Distance from either end of bedplate to nearest wall obstruction
Additional Comments
CAPTCHA